Turn Signal Beeper and/or 4-Way Flasher
Note: Requires two incandescent bulbs to operate.
This Turn Signal Beeper/ 4-Way Flasher combo kit is designed to be installed completely inside the right side cover. No soldering required. The turn signal beeper is activated when either the left or right turn signal is on. When the hand or foot brake is applied the beeper will stop while the turn signal continues to blink. The beeper will start again when the brake is released. After completing your turn, you must turn off the turn signal and the beeper will stop. By turning the flasher switch on it will activate the 4-way lights and mute the beeper.
To ensure customer satisfaction DO NOT use Glen's 4-Way Flasher and/or turn signal beeper with any run-turn-brake modules.
The following
are included in the Turn Signal Beeper/ 4 Way Flasher combo kit:
1 - Assembled 100dB Turn Signal
Beeper/ 4-Way Flasher
3 - Wire connectors
3 - Wire connectors
2 - Wire ties
1 - Switch mount clamp
1 - Pictured installation instructions
Kit cost - $50.00
1 - Switch mount clamp
1 - Pictured installation instructions
Kit cost - $50.00
4 Way Flasher
Note: Requires two incandescent bulbs to operate.
By turning the flasher switch on it will activate the 4-way lights.
No soldering required.
To ensure customer satisfaction DO NOT use Glen's 4-Way Flasher and/or turn signal beeper with any run-turn-brake modules.
The following
are included in the 4 Way Flasher kit:
1 - Assembled 4-Way Flasher
2 - Wire connectors
2 - Wire ties
1 - Switch mount clamp
2 - Wire connectors
2 - Wire ties
1 - Switch mount clamp
1 - Pictured installation instructions
Kit cost - $35.00
Kit cost - $35.00
